The beginners trying to string a weed eater with two separate holes can find it difficult to change the string at the first go. However, with time, they can get accustomed to the process of replacement as the entire procedure is not as tough as it looks.
Learning the process of stringing a weed eater is simplified in the following steps, especially when the toll comes with two separate holes. You can learn the easy technique of stringing a weed eater with two holes in no time just by following the details mentioned below.
You can also visit https://www.homegearable.com/best-cordless-string-trimmers/for the best cordless weed eaters.
The Process of Stringing a Two-Holed Weed Eater
You must understand the process of putting a string on a weed eater with two holes before directly executing it. The incorrect stringing leads to issues and can result in increasing the level of frustration in your mind. The following are the steps of appropriately string the two holed weed eater:
- You must keep the new string handy before starting the replacement process. You must check the manual of the weed eater to determine the length of the string required by the tool. You can use the line of trimmer needed and cut the remaining part of the string with a scissor.
- In case you do not have a trimmer line, you must ensure that the string’s width matches the width of the existing string in the weed eater equipment. The width of the string will ensure your weed eater to perform in the smoothest manner possible according to its design. You can find the exact width of the string in the manual or on the official website of the tool’s manufacturer.
- You must turn off the weed eater entirely before you start off with the replacement process. The batteries and the power line removal are the primary steps that you must do before operating on the tool. In case the device is heated, you must wait for it to cool, especially the area where the gearbox is present.
- You now need to reach the area at the bottom called the cap of the weed eater usually where the string is out. This area helps in holding the string present on your weed eater, and you must follow the technique of opening it in the way as mentioned in the manual. You need to push the tabs on either side to lift up the cap.
- You can locate the visible hole in removing the cap. You must now locate the exact center of the string and fold it into halves so that it becomes equal on either side. You need to place the center in the notch of the starter and pull it tightly. You then need to wrap the string around in a gentle manner. Avoid overlapping of the string while wrapping.
- For the weed eater that has two holes for inserting the tip of the string, you must use the arrows here that show the direction on the cap for wrapping the string around in the exact given direction, mostly counter-clockwise.
- On following the straight arrows, you can easily avoid jamming while wrapping. When completely wrapped up to the last 4 to 5 inches of the string, you need to place the cap to retain the position so that no distortion occurs. You must repeat this process for either end of the string.
- Make sure that the string passes through the loopholes on the head of the weed eater. Reattach the cap and place the pool.
The process of stringing a two-holed weed eater is simple when you get accustomed to it. The alignment is the key which on performing correctly, you can master the complete process altogether.